Quote:
Originally Posted by Virterm
Just get an inexpensive multimeter. What I would suggest to do is as follows:
Disconnect the lights, or better just the AE bulb ( or cable) and see if the error goes away. Then, measure the voltage between ground and pin 1 (AE). Also, I would suggest to compare resistance ( ohm meter) on both lights AFTER disconnecting them. Measure between pins 1 and ground.
This way we should be able to see if the unit is even trying to power the AE and also if you have short in the housing.
|
Btw, the bulb resistance should be around 4 ohm....if I calculated correctly....