Quote:
Originally Posted by Soravia
Here is for Safelite Autoglass in Clarksville, but this could be anywhere.
Had my windshield replaced under insurance and the guy who replaced glass broke the windshield cowl (51717180743), threw away bottom windshield bottom moulding (51137133292) that holds the wiper washer cowl tight on the glass, and hid it all from me, while putting too much sealant so replacement windshield bottom moulding won't go back on.
Got my car interior flooded through the HVAC due to big hole in the wiper cowl.
Good thing I caught early before mold builds up and total the car.
Don't use Safelite Autoglass or anyone not properly trained on BMWs.
Here are the pictures.
New windshield bottom seal in picture was installed after a lot of cutting on the excessive sealant. Yes, two screws were intentionally left out so the cabin filter cover would seal better.
|
Same thing happened to me but not by safelite. I'm convinced it's impossible to get anything done right in Tennessee. It's literally insane.