These are super easy, will take you all but 5 - 10 minutes. There's really no need for a guide but in case you have apprehensions here's the really drilled down version...
No bulb alerts on dash, nice plug and play set up!
Remove the panel by pulling on the outer edge.
Use Torx T-20 driver remove the screws. use caution, do not drop them.
Old light will come out. remove the electrical connectors.
connect the new male blades into the female factory terminal connectors.
I seated my blades in with a jewelers flat head screw driver by pushing on the blade into the connector.
RED to Gray
Black to White
if you mess them up dont worry, you can swap them, no harm to your car.
When you install the LEDs the angled side goes toward the middle of the car.
i zip tied everything to make sure there would be limited movement and no rattles.
Stock on passenger side, LUX on Drivers side. No bulb alerts on dash.
Both are in.
Reverse lamps are lighting from my garage, down my 4 car driveway, and across my two lane street. a minimum of 100 feet away. HUGE improvement.
they are actually lighting up the front of the neighbors house
lol