Hey guys,
First post here. I just replaced pads and rotors on my E91 328xi wagon. I bought this exact kit from FCP euro:
https://www.fcpeuro.com/products/bmw...6ktfr4#fitment
I installed the rear pair yesterday, everything went smooth enough. However after going for the initial drive I noticed the coating has not been removed from the inside part of the rotor. My guess is the pad is not fully contacting the rotor?
View post on imgur.com
View post on imgur.com
I don't imagine the pads are in wrong as the tabs seem to only fit one way, and I copied how the previous pads were set in the caliper. Did I do something wrong? Is this typical? Note it is like this on both sides, so if I installed correctly I did the same on both sides.
Thanks