Quote:
Originally Posted by 07tundra
I see alot about wiring and pining so my question is if I have a manual car with the wiring harnesses from the MT can I just take that and transfer it to my AT car and call it a day along with the clutch module and what about the backup wire to turn your reverse lights on? I'm about to start still very muddy on the wiring only reason I haven't done my meth kit also.
|
Not quite that easy, you do need the AT harness for the DSC module. I had trouble with this while programming as the ground the DSC module was not plugged in on the AT harness side. Depending on the year you may need to do some additional wiring if you don't have the wires going from DME to Clutch switch module and CAS to Clutch switch module. Reverse light should have its own connector on the manual trans harness and shouldn't require additional wiring. I'll have to look at my Bentley Manuel again to check the wiring specifics.