|
ok scratch that… I have 6 lines going into the unit. reading on INPA I now get a 51B0 Code(Brake Pressure Switch) DSC Signal Not Plausible…… Can that Sensor be replaced, from what i see its built into the unit. Also Can that unit cut off communication to the "VGSG Module(VTG)"? bc through INPA I get D_VGSG NO RESPONSE FROM CONTOL UNIT…??
Also Is -08-09 a normal vacuum ready.? only reaches -10 a times. NO 30FF Codes.. replaced a lot of vacuum hoses. no change. I am Reading vacuum through a CMGS Boost Guage/Progressive Meth Controller.
|