Quote:
Originally Posted by Rob@RBTurbo
Not sure where you are getting these measurements, but there are certainly no restrictions in IC's due to the use of OE circlip style connections. They typically ID out around 2.4", very typical of most IC's on the market and also perfectly inline with the ~2.5" OD plumbing that supplies them to and from.
On another note this outlet does look very nice. Good work.
Rob
|
Measure the ID of the OEM outlet adapter which when installed is inserted INTO the OEM interooler's inlet and outlet Rob. That's where the restriction lies. When utilizing OEM connectors, you're limited to the ID of the OEM inlet/outlet adapter which are certainly not 2.4", but less than 2" ID.