Quote:
Originally Posted by streetpro
in reality it took me like 3mins per side to get them in, just use proper tools... table grinder or simple hand fill do the job... just shave off couple of mm of each side of the arm joint and it slipped right in...
btw best mod ever, it transforms the car from dull heavy boat into a eagerly steering joy machine
|
This definitely needs to be mentioned in the DIY in my opinion.
There was no possible way the wishbone arm was going into the subframe without modification.
Grinding either ball joint mounting face or the subframe is a must. I don't have a table grinder to just place the arm on so I had to dremel the subframe mounting bracket down. Anyone else planning to do this should make sure you have some sort of grinding tool. Buy a few grinding stones lol. If all i had was a handheld file, I would have been there all day. Dremel took care of it in a few minutes.
Edit: Wishbone is the rear control arm in the front.