If laziness is mother then daddy is frustration and I'm bout to take it out on the torque app.. I cannot get it to connect for the life of me.. Did anyone get a "select the right baud rate" message and can't connect? At this point I'm done with torque pro unless you guys have an answer.
Maybe I have already found my problem after digging into the forums.. I have the bimmer geeks k+dcan usb cable and well I haven't gone down yet but I'm pretty sure I just need to switch it from k to d can on the obd2 connector itself.
Last edited by blk35d; 05-01-2019 at 06:32 PM..
Reason: More info
|