View Single Post
      09-27-2008, 03:56 PM   #2
Major General

Drives: TS330iPPSP6MT
Join Date: Jul 2005
Location: Planet Earth

iTrader: (3)

Step 1. Remove the micro filter. Use the 5/16 hex socket and remove 6 screws and just lift the micro filter housing out.

Step 2. Remove both covers on each side of the micro filter. Each one of these cover has 2 clips and a rubber tie down (red circle), locate and pop both clips loose, then pull the cover up and out of the rubber tie down. With these covers removed, you should see another hex screw (yellow circle) that hold the cowling in place. Remove these last two hex screws as well (one on each side).

Step 3. To remove the cowling you need to pull out the rectangular harness that holds the wiring.
Attached Images
under construction!