Quote:
Originally Posted by Steve Sas
Recheck the pan bolts to see they haven't gone loose.
Also check the main electrical connector which is a common area that leaks with age.
Maybe moving thinks around caused the seal to start leaking. This is why its best to replace as many seals as possible when doing a transmission service.
|
Thanks, I'll take a look at them tomorrow morning. I have noticed that the electrical connector is usually covered in fluid so it's likely that it is in fact leaking from there as well. I think I may be redoing the job and replacing all the seals to be safe.
Quote:
Originally Posted by thomas1097
There is a specific order in which you tighten the bolts. You can't just tighten them willy nilly one after the other. It's like a cross sectioning pattern you have to follow
|
I did follow the torque order, however I didn't have a torque wrench at the time. Is it possible to cause damage to the gasket by over torqueing the bolts?