|
Don't grease the pins. Especially not on the factory rubber boot. There's a chance that the grease and the boot may react and oxidize over time and cause the pin to bind. If you DID grease the pins, I'd take them off and clean the pin and the booth thoroughly and re-install.
The only time you SHOULD grease those pins is if you installed brass guilds. Since it's steel on brass, you need to grease it regularly to prevent it from binding. But rubber on metal? No.
__________________
Sitting on a beat-up office chair in front of a 5 year old computer in a basement floor, sipping on stale coffee watching a bunch of meaningless numbers scrolling aimlessly on a dimly lit 19” monitor.
|