Quote:
Originally Posted by Silver Streek
As I understand it the 6 cylinder engined cars don't have the reluctor ring set up, that set up is used on 4 cylinder cars.
Please correct me if I am wrong.
|
My Wife's car is a Canadian model 2011 323i, the base model below the 328i, comes with a 2.5L six instead of a 3.0L. Rear sensors are the reluctor ring type. Car was built in the USA late 2011.
I put a new sensor in to replace the one that was worn from the swollen reluctor ring, but I left it out about 1/16". Took it for a drive, all lights cleared within 30 seconds. I'll be adding a washer under the M6 sensor bolt as others have done, and on both sides in anticipation of the other side not being far behind having the same issue.