Quote:
Originally Posted by avenger2540
Those arms seem like they dont include ball joints so how did u press them into the new arm? Is it as simple as popping them off with that tool and when putting it back on the car just keep tightening itl pop it self back in? Please let know km getting some rediculous quoyes for labor and on top of everything I have to replace the position motor on teansfer case I hate xi
|
1+ I also will like to know this if any body know? I will put my tomorow.[/QUOTE]
Yes they just pop in by screwing the nut onto the ball joint
If the nuts turns without tightening , slowly place a jack underneath and slowly jackup under balljoint but not too hard then tighten then tighten the nut. It becomes pretty hard to tighten