Quote:
Originally Posted by ctuna
I would go with the 2ohm load just because I
would not be comfortable going lower.
2 x 550 W RMS @ 2 ohm which also give stereo.
But Jehnert should know best.
which means two sets of two speakers in series
and each set of two in series in parallel with each other.
Assumes you use the other 6.5 for an under seat.
That is still 125's watt per speaker.
They sell the doorboard's with two or 4 6.5 with the fourth
intended for the under seat position.
If it was me I would just run two 6.5's in each door and a
xe-200 for the underseat to get a little more midbass.
|
If i went with 2 ohm load with 4 speakers per side, would the wiring go
as in picture at post #4 ?
That would give around 137wrms per speaker therefore underseat XE-200
would get a nice upgrade aswell.
How would it work having one 8" midbass mixed with three 6,5's ?
Jehnert crossover giving the same play band for 8" and 6,5's ?
So at ~1.33ohm 3x 6,5's per side wired parallel or
at ~2ohm 4x 6,5's (1x 8") per side wired like in picture at post #4 ?
