[BMW ONLY]

Originally Posted by wynes

Hi there,
I’m new to this site so I’m hope I’m posting this in the correct place - I’m sure I’ll be corrected and pointed in the right direction if it’s not.

I was driving the other day and accelerating reasonably hard in 3rd gear and around 5000rpm (I think) I received the “engine malfunction reduced power” error come up on the dash and CIC. I have had a similar issue in the past, but this time the engine really went into limp mode and was barely enough power to keep the car from stalling.
Anyway, same old story, turned the car off, let it rest for a minute or so and everything returned to normal.

Here’s a list of my error codes from Carly, hope someone can point me in the right direction as I’m pretty new to e92’s

This seem to be the main issue,

Motor Control:
Engine / Motor
Internal Error DME
Code: 0036C9 / 36c9

I’m pretty sure this one turned up at the same time,

ABS / DSC / Brake:
Dynamische Stabilitaets Kontrolle / DSC
Engine torque is not adjustable CAN
Code: 005E19

This is the freeze frame Data,

Faultcode: Internal Error DME
Faultset 1:
(appeared at: 99320.0km)
speed monitoring:
0.00 1/min
Engine torque actual monitoring:
478.00 Nm
Engine torque setpoint monitoring:
28.00 Nm
inserted syringe fuel mass:
98.00 l/h
Faultcode: Internal Error DME
Faultset 2:
(appeared at: 262144.0km)
speed monitoring:
0.00 1/min
Engine torque actual monitoring:
254.00 Nm
Engine torque setpoint monitoring:
96.00 Nm
inserted syringe fuel mass:
39.00 l/h
Faultcode: Internal Error DME
Faultset 3:
(appeared at: 784.0km)
speed monitoring:
560.00 1/min
Engine torque actual monitoring:
0.00 Nm
Engine torque setpoint monitoring:
256.00 Nm
inserted syringe fuel mass:
239.00 l/h
Faultcode: Internal Error DME
Faultset 4:
(appeared at: 312.0km)
speed monitoring:
1920.00 1/min
Engine torque actual monitoring:
196.00 Nm
Engine torque setpoint monitoring:
0.00 Nm
inserted syringe fuel mass:
127.00 l/h
Faultcode: Internal Error DME
Faultset 5:
(appeared at: 30584.0km)
speed monitoring:
5120.00 1/min
Engine torque actual monitoring:
78.00 Nm
Engine torque setpoint monitoring:
0.00 Nm
inserted syringe fuel mass:
0.00 l/h



Any help would be much appreciated, many thanks in advance!!
Cheers!

I had the limp mode a couple of years ago. I didn't check for codes. I only changed my spark plugs and cleaned the eccentric shaft sensor.