Quote:
Originally Posted by aaronblack
From everything that has been said it seems that the most reliable options (subjective) in order are:
1- Map-out
2- NOxEM
3- OEM NOx
NOxEM seems to have some quality issues, yet some have also had great success! Map-out seems better as it has no sensors/ecu etc yet no remapper has confirm all 3 stages in any my emails!
I'll call Map-tech and see whether they'll confirm the 3 stages.
|
Quote:
Originally Posted by Dormermike
Think I'm going to get the OEM nox.
Anyone know what goes wrong with the original nox sensors? I wonder if its a simple mosfet fail or a (more likely) aged sensor in which case perhaps replacing the sensor head is possible...
Edit what is that component bottom right, looks like it could be a battery?
|
Quote:
Originally Posted by schriss
I don't think it's a battery, if it needed to save some data for power-loss situation thats done with eproms I think.
I might put loads of silicon grease on my NOXEM when we install it  It does seem like it's closed shut for good, can't even see any gap between plastic and metal.
Re original NOX sensors they just last for a given mileage, like 100k. Sensor is the problem, not electronics, sensor simply clogs up more and more, or so I read. Mine is like that. INPA shows Offset value outside of range. Also it reports over 200ppm of nox when driving, not sure if that's supposed to be so much. |
Quote:
Originally Posted by aaronblack
From everything that has been said it seems that the most reliable options (subjective) in order are:
1- Map-out
2- NOxEM
3- OEM NOx
NOxEM seems to have some quality issues, yet some have also had great success! Map-out seems better as it has no sensors/ecu etc yet no remapper has confirm all 3 stages in any my emails!
I'll call Map-tech and see whether they'll confirm the 3 stages.
|
I doubt any will confirm it, they do not have the in-depth knowledge or the engine and the ecu.
Please make sure you have inpa and understand how to reset adaptations.. adaptations will also cause issues with running all 3 modes.. msd80 is ultra sensitive, also confirm which firmware you are running bimmerproffs have a really good page on tests they have do e with different firmware.