Just got it in today after.... almost 20 days?
First impression: Looks good. Nice fins and gloss finish.
I decided to just try the tabs out and see if they fit into place. I didn't even put it in yet, but as I aligned it and put it on top of my stock diffuser.... It doesn't line up. The diffuser is too "straight" while our diffusers curve in a little bit.
I took my old one off and tried to clip these in forcefully to see if it may just need a push. Got one side in and the middle clips were a bit thicker than I had hoped. Needs a bunch of shaving.
Overall, I think it is possible to make this work. No custom fabrication needed, but I'll have the shop shave the clips and work its way through...
Stay tuned. First look below..
