I have xprog 5.55 up and running, and am using the BDM method to try and revive it, but now I'm encountering an issue where any read/write activity to the EEprom results in an error message:
'Can't get access to BDM'
My device is set to try and read/write under MC9S12XEQ384_EEE.
Tried reading the P-flash and got the same message. Mike suggested a 12V power supply, which I have tried, but still no luck. Could it be the BDM adapter? The BDM points are also just connected with some blue tack and tape...have to go buy a new soldering iron and I'll try again, but just wondering if there's anything else that I should be looking at?
|