Quote:
Originally Posted by hotbox
Quote:
Originally Posted by opjose
If you've obtained an image of the old CIC, you'll do fine.
I suggest reading out the configuration of your old CIC, installing the replacement CIC and coding it with the config you read out, then swapping in the SSD drive.
The replacement CIC will pick up the FSC codes from the SSD drive and you should be all set.
|
How would I go about doing this, with the use of FSTool or something else? I assume that this would then allow the navigation and combox to all work with the new CIC, but does it matter when the replacement CIC was manufactured?
Thanks for the information! |
Use INPA to read out the coding of your current CIC.
Then apply that to your replacement unit.
Hopefully the replacement unit will have a close revision level and will work without updating.
If not it may have to be updated.