Quote:
Originally Posted by greenohawk69
Replaced the driver side front door actuator on my 06 (E90) 325i.
Followed most of the instructions, but did not disconnect the batter nor remove the window. I did remove the nuts on the support for the window for extra room.
I also used a dremel on the lower right opening and expanded it approximately 1/4" - which gave me enough room to slide in/out the actuator with relative ease.
I did have to redo the process as I did not securely clip in the the pull wire that connects to the back of the actuator. Fortunately I knew the process and no new swear words were used as the old standbys worked well.
|
Make sure you plug in the molex to the actuator when all door locks are in the same state (all closed or all open). Sometimes the system gets confused if they aren't. See my post above.