Quote:
Originally Posted by Sensible_
When you programmed the eeprom did you write the VIN? Or blank it?
I always blank it and 0 odometer.
Try to write a backup dump to the eeprom then FF the VIN. Then code with NCS and VIN will be written properly.
|
I pulled my EEPROM and cleared the vin, all i did was change the 2E0 line from what it was to all FF's then put it back in my car. i got the tamper dot again so i know it cleared. i coded it to my car with NCS then the dot went away and i got the same error i always got. i just ordered some new M35080 eeprom chips that should be here in 2 weeks to see if maybe the EEPROM is bad?? do i need to write anything at all to them or just install it on the clusters mother board blank? will the car automatically write to it when i use NCS expert to code it? hopefully the new EEPROM works.