Quote:
Originally Posted by Dan-
Thanks for the reply, is that done using NCS? I’m new to all this unfortunately, I shouldn’t need to write the vin to the module as they have always been installed in the car! Is this the process for coding/resetting the module
Open NCS
F1
F3
Select E89
Ok
Select NFRM
Back
Process ecu
Select RSMC
Change job ‘codierdaten’
Execute job
Change job ‘sg codieren’
Execute job
Thanks
|
This doesn't seem to work in my case. It keeps saying ECU BUSY REPEAT RESULTS.
I cannot do a codierdaten_lessen or SG_codiern to either LSMC or RSMC.
I am trying to code in a used right side AHL headlight. My driver's side one works just fine but I can't read or write to LSMC too. All other ECU s can be read/written without problems.
Any thoughts guys?