11-15-2019, 11:41 PM
|
#81
|
Supreme Galactic Commander (one galaxy over...)
Drives: '08 E93, '12 E82, '13 E93 M3
Join Date: Feb 2012
Location: Washington, USA
|
1. Thank you for this thread. Pretty much matches the Bentley Manual.
2. Thank you JPuehl for loaning me the tool.
3. My loctite gasket maker came with no plunger. Was scratching my head for a while. Got one from some horse syringes we have that happened to fit.
I found it frustratingly hard to get any flow rate from the specified tip. I did jam it in the place where the grooves were (and I lined it up correctly) but it was so tight I am not sure I got anything in there very far.
4. I switched to a larger tip to slather the gasket maker on the front of the seal and around the edges.
5. We'll see what happens when I start it up tomorrow...as soon as I figure out how to fit a stock fan onto a CSF Radiator (separate project I was doing in parallel)...
__________________
Best,
Andy
'12 E82-PS2,Stoptechs,Clubsports+M3 bits,Accusump,Wagner DP+EVO III FMIC,ERCP,BMS Intake,Mason Strut Bar,Wedge Tune
|
|
|