Quote:
Originally Posted by GEOS07335i
I think my OEM turbos are on the way out. I keep getting smoke on cold start where engine idles below 1000 rpm. It goes away after a little driving. No water in the oil. It's not blue smoke. If I had to guess it's blown seal in the rear turbo. I see a little oil on my DP's. VCG has been replaced.
Anyway looking for a cost effective alternative to the OEM's Are there any options in the $1000-$1500 range.
What's the typical cost to install?
The only options that I have found are:
Are there another options?My intentions would be to add inlets/outlets and stg2 LPFP on e40. I believe I already have the other supporting mods: FMIC,DP's,CP,DCI, new plugs, coils walnut blasting, upgraded PCV.
I'm assuming at this point I'd be maxing out the auto trans, fuel system and turbo's efficiency.
|
Not sure if anyone mentioned it yet but Pure Stage 1 should be considered in this thread.
I can't link back to my site in non classified sections otherwise I'd send a link.