Quote:
Originally Posted by tomshong
so, let me get this.... Once I build the board (building the circuit is the fun part for me; I have a MS in Electrical Engineering...), here's what I can do...
1) Open the light/roof panel (I will figure it out...)
2) Find the two wires that run into the clown nose (what color are they exactly?)
|
I think they were black and brown, but once you open mirror cover there are only three wires that go to LED. I used 9V battery to find which one -- it was easy.
Quote:
Originally Posted by tomshong
3) Connect the two clown nose wires between Pin 3 and 8 of the TLC555 (where does these two wires end up at by factory default? )
|
I am not sure where LED wires go by default since I did not spend any time tracing them. But based on Ohm/Volt-meter readings it does not look like they are connected to anything until factory alarm is installed.
Quote:
Originally Posted by tomshong
4) Connect the end of R3 to the Connection 1 of the 'black box', and then ground the whole thing (where is the ground at exactly??).
|
I used bolt next to a sunroof motor for ground wire.
Quote:
Originally Posted by tomshong
5) tuck everything inside the panel and put everything back
6) Wha-La!
Is that it?
|
Yes, that is pretty much it.