Alright my first coding adventure has failed and I don't know now, hoping someone can help as I can no longer do anything
Setup
bimmergeeks cable
bimmergeeks standard bmw tools
ncs expert using manipulation profile from bimmergeeks
Scenario
Wanted to code window roll up with fob
Steps
Loaded NCS Expert, chose "Manipulation" profile
Downloaded the trc file and modified the line KOMFORTSCHLIESSUNG_FB to aktiv
Saved the file as .MAN
Reloaded NCS Expert in coding mode, tried uploading the changes and...
Received the following error
Exited out of NCS Expert
Tried reloading and reading loading the CAS module (or any module) and now receive this error)
After everything, I also noticed that my VIN was off by 1 digit, should have ended in 2 but it ended in 1 inside of NCS Expert
If I open my TRC file in NCS Dummy, I'm also getting this error
[E] 20:24:23 An error occurred while reading "C:\NCSEXPER\WORK\FSW_PSW.TRC": Unresolved function keyword "CODIERUNG_ERFOLGT". Make sure chassis and module match those of the trace file.