|
First time is about an hour be patient and work slow.
the vacum lines are a pita to remove, dont use a tool just be patient and work them off. same when putting them on just be patient.
wires are easy but make sure your male to female connections cant come loose.
fuse, mine was a pain to plug back in but it went with a minimal amount of force. I used a little screwdriver to seperate the clamp on the included fuse clip then I used pliers to crimp it back down once attached the the wire (this will make since when you get to that step.)
if you get a code dont panic just double check eveything and post on Vishnu support forum and they will help you.
Be Careful
Be Patient
Dont get frustrated
P.S.
Wait for your engine to cool.
|