Quote:
Originally Posted by Biginboca
I also noticed the outer edge of the rear rotor looks like it's seeing some unusual wear in your pic. Could this be because you used an angle grinder instead of milling the calipers and the mount surface isn't square and true?
[img] https://s15.postimg.cc/bzgs2vel7/A0_...D8253331_F.jpg[/img]picture upload
|
Lol good eye! No it's just that I got 3 miles on brakes and the film is slowly wearing off and likely higher friction towards center hence progression, but did look at same thing first!
if you look at outer you will see 1-2 millimeter which stays. If I took picture now, you only see the outer 1-2 millimeter. Trust me the surface/level of the planed face after grinder is on point and square which was confirmed by measurements in several places prior to install. Also this is picture after 5-6 miles and you get idea/see pattern.