Quote:
Originally Posted by mrjcover
If we already have the PPK flash installed, do you recommend flashing back to stock prior to install???
|
Not required. I have the PPK installed on my car also.
Quote:
Originally Posted by GreQonE
Question: If I already have a bench flash that satisfies my tuning needs but I would only like to change "burble" settings, is that possible? Or will initial MHD flash overwrite my bench flash settings?
|
MHD would overwrite the bench flash.
Quote:
Originally Posted by CantCatchMe
When you guys use the battery charger, do you guys put it at 12v and 6a? I normally tend to put it at that setting when I would upload the Cobb maps.
|
Depending on how good your battery is, a 6a charger should be fine to get you through the first flash without voltage dropping low enough to cause an issue. Reflash is only 4 min so you won't need a charger at that point.
Quote:
Originally Posted by jake1220
If 6a is the most it will put out then yes. Mine has a 35a setting and that's what I use. The car will pull obscene amounts of current while flashing.
|
Over charging can be as bad or worse than a drop in voltage. More is not always better.