|
Just like some of you guys i'm having the same problem. Abs/dsc/cruisecontroll/ftm errors.
What i've changed:
Abs sensor
wheelbearing
I get the following Errorcodes:
Dynamische Stabilitaets Kontrolle / DSC
Fault Code: 005DB1
Fault Explanation: :Yaw rate sensor DRS sends signal AY1 = invalid.
(DRS-type MM 3.x). / Rear wheel speed sensor Left continuity
(extrapolation) / Speed sensor, rear left extrapolation. / Steering angle
sensor error jump / Yaw rate sensor DRS sends signal AY1 = invalid;.
DRS-type MM 3.x --- (DSC: DSC sensor internal) / Yaw rate sensor DRS
sends signal AY1 = invalid (DRS-type MM 3.x).
Fault Code: 005DB6
Fault Explanation: :Yaw rate sensor DRS sends signal PSIP2 =
unueltig. (DRS-type MM 3.x) / Advance Sense rear left. / Yaw rate
sensor DRS sends signal PSIP2 = invalid;. DRS-type MM 3.x --- (DSC:
DSC sensor internal) / Yaw rate sensor: DRS sends signal PSIP2 =
ungeltig (DRS-type MM 3.x). / Excessive initialization time error
Fault Code: 005DE2
Fault Explanation: :coding missing / DSC-ECU: ECU-internal: DePwm
Status: software / hardware configurations do not match (DF11i / s). /
EU-valve 1 / Lining Wear VA reaches critical coating thickness. / DSC�ECU: ECU-internal: DePwm Status: software / hardware configurations
do not match; DF11i / s --- (DSC: controller internal)
Fault Code: 005DB3
Fault Explanation: :Inlet valve (EV) Back Right - Error cyclic valve
and relay test. / Inlet valve (EV) Back Right: Error cyclic valve and
relay test. / Inlet valve (EV) Back Right: Error cyclic relay valve and
test --- (DSC: control valve actuation device) / Wheel speed sensor
rear left start up detection (comparison) / Speed sensor, rear left
detecting starting v comparison. / Lateral acceleration sensor
calibration error missing
|