Quote:
Originally Posted by freedomfries
Quote:
Originally Posted by dleccord
Hey guys. For enflinks do you guys recommend using loctite so it doesn't loosen? If so which kind of loctite?
|
I recommend it after having the nuts loosen on me. Medium strength should be fine
Quote:
Originally Posted by parksjm7
PSB by Armstrong. I did not have to lower the rear subframe but it is a tight squeeze to fit the 10mm wrench in there.
|
Thanks for sharing. I just ordered these after verifying my RSB was 13mm. I could move the bar very easily by hand so hopefully these bushings tighten things up
https://www.armstrongdistributors.co...ing-13mm-06-12
|
hope they work out for you - I felt the rear end a bit tighter than I'd hoped for so I changed the fronts to poly as well. fronts were much easier