|
You did the correct thing.
Can you tell me how did you do a coolant flush? Did you remove the FMIC or not?
If you only drained from the heat exchanger then you did a 3/4 flush.
Still not bad, but recommend doing another 2-5 more flushes.
This way the oil in the coolant is diluted to less than 5%.
Here is another trick... If you drained from the heat exchanger by following the coolant flush DIY.
Then after the coolant drains.
Squeeze the rad hose going from rad to the OFH.
Squeeze and release it repeatedly.
Listen to how much more coolant comes out.
Inspect each drain.
Make sure to do a purge after each refill.
Oil you may not have to drain again and again....cause our oil heats past 100 degrees Celsius.
And any water will evaporate.
This is normal for our cars as inherently the oil condenses water during cool down.
Just change it at 1k or less, but should be ok.
Simply Green is your friend around the engine bay to safely dilute the oil and then can be washed off.
Your ok...
IMO.
DN
|