Not exactly, i didn't liked the idea of drilling holes, i wanted clean look as much as possible.
I places the board on the same angle but i left the lens to hang as i can adjust it later.
I used a piece of rubber so the lens can hold tension and not move around or vibrate
I also ran the wire in the little hole, for that purpose i had to cut the usb cable and remove the shielding on the one end so its more agile.
Then i used a second USB cable to extend it all the way to the fuse box
And i can easily access it to transfer the needed files
I also had to make a special tool to remove my glove box, cuz i was too lazy to go to the store
