Quote:
Originally Posted by hupchye
My Can Bus Bridge/Repeater circuit has been successfully designed and tested - with STM32F103C8T6 + MCP2515 module (CAN1) + TJA1050 module (CAN2), Can Bus Sniffer with Arduino Uno + MCP2515 module.
If my 4cyl BMW DME cannot accept ACC Active Cruise Msg ID 0x0AA AccPedal, it is time to integrate the Can Bus Bridge/Repeater in between PT-CAN and LDM module to translate certain Can Bus commands, perhaps simulate Stop & Go as well...
|
Any info on how to setup a can-bus reader/sniffer?