Quote:
Originally Posted by HydroxFrost
So after my car being a massive pain lately, I had to replace the o2 sensor (Bank 2, sensor 1). Ended up taking it to a mechanic because I couldnt get the bracket bolts off for the life of me, turns out he couldnt either so he cut around the bracket. Anyway, he got the new o2 sensor in and it was stalling on the way home until I cleared the codes, went for an hour long drive without any stalling or issues before I parked it to deal with my tie rod nightmare, noticed the code had returned at some point during the drive but never had any stalling or issues. Today, after replacing my inner and outer tie rods I drove it 5 minutes to an alignment shop. I stalled out every time I had to stop, the P112D & 2C3E codes persist for the same sensor I replaced. I'm assuming its a fuse or wiring. How might I go about fixing this? I'm good at just about everything that doesn't involve electrical. Anyone have similar issues that they fixed?
|
Check the other 02 sensors...