[Soravia]

So I got this in front of the door! What's in it?
Turner Motorsports did say they have Bilstein B6 kits for as low as $600 if you call in and ask right now!

I also ordered a 22 mm strut nut tool because I know Bilstein nuts are larger than 21 mm OE nuts.
Not yet pictured, M3 suspension arms, bushing inserts, new OE bushings, replacement spindles with new OE bearings, sub frame bushing inserts, and more

What's getting done.
Front
Bilstein B6 HD Dampers, mounts and all hardware
Tension strut with polyurethane added bushings, wishbone replacement with all hardware
Spindle, Hub bearing, tie rod ends, all.hardware
Front axle shafts and seals, because road salt trapped behind wheel cap rusted out the 36 mm nut on drive shaft, and seals
Front differential input shaft seal. It has a good amount of leak showing after I cleaned up.
OE spec Uro brand engine mounts, filled with 60 duro meter polyurethane.
335i rebuilt calipers with brass slide pins, stainless steel brake hoses.
Anti-sway bar links

Rear
M3 sub frame with bushings and new bolts
M3 control arms with specific hardware
Megan M3 adjustable rear toe arms
Spindle, hub bearing, and rear axles with hardware
Rear flex disc with hardware
New hard brake line pipes to replace rusted out end nuts
Stainless steel brake hoses
Control Arm bushings
Drive shaft support bearing
Exhaust coupling clamps
1M, E93 mid to rear reinfrocement and necessary push rods to mount with rear sub frame. Original push rods are all rusted out.
Rear anti-sway bar links
BimmerWorld 60mm rear spring upper perch
Turner Motorsports 60mm spring isolator pads for upper
Energy suspension 60mm spring isolator pads for lower

Remove rust and repaint front sub frame edges, rear under body panel seams, sub frame mounting points, clean and coat with rubber coating as much as possible