Quote:
Originally Posted by iqraceworks
FYI....you can also get a set of large metric open end wrenches (including 50mm) from Harbor Freight for around $60.
|
I did consider that, but it looked like the HF wrench was a tad too thick and would require grinding down to fit. What I did get at HF though was a Bearing Separator and Puller Set (#62593) for $50. It made short work of removing the CSB from the driveshaft.
BTW, the new insert nut is a whole lot easier to put on than it was to get the old one off. I guess it takes 15 minutes or so for the thread sealant to kick in.