Thanks.
Quote:
Originally Posted by socalcoding
In INPA UIF is it showing the correct time stamp for flash on DSC, ABG and FRM?
|
I'll check later. and also post error codes from INPA.
Quote:
Originally Posted by socalcoding
The second part to frm replacement programming is to copy VO from CAS and FA write to FRM. Once that's done, default code FRM with blank MAN file. The frm should then be coded to the car correctly.
|
This is to be done on NCS Expert as below right?
Quote:
Originally Posted by socalcoding
As for DSC and ABG, default code those modules in NCS Expert and the faults should erase themselves, clear codes with inpa after.
|
.
Quote:
Originally Posted by socalcoding
Make sure cable latency is set to 1 ms and com port 1.
|
This I have checked and all OK.
Quote:
Originally Posted by socalcoding
Make sure daten's are also updated if you are running into errors trying to code in ncs expert
|
I'm using the Bimmergeeks download and installed as per the instructions. I keep getting a VIN error COAPI-2000 Errors. I tried updating with the E89 Daten from Bimmergeeks through BMW coding tool using this guide and now get different errors.
I'll post up some screen shots tonight.
Thanks again.