View Single Post
      10-01-2011, 07:31 PM   #9
Dr Zoidberg
New Member
United_States
7
Rep
26
Posts

Drives: 08' 328i
Join Date: Mar 2011
Location: Gainesville, Va

iTrader: (0)

I am in the middle of changing my fluid and filter.. A trick to pull that "o-ring". Its not really an o-ring, its a metal seal ,
In a couple spots, I just took the end of a screwdriver and pried it into the center of the hole. then lightly tap the metal seal into its self with the screw driver and hammer, this began to rotate the seal. At this point you can just grab it and pull it out.

To install , I just found a socket that had the same diameter as the seal. I wet it with fluid and started it by hand , then tapped it in with the socket.

Now Im waiting for my girlfriend to get home so she can run the car while I fill the fluid.
Appreciate 1