|
Complete setup
A couple of more pictures with the whole setup. It turns out, with a little practice you don't need a third hand to hold the vacuum adapters. It proved to be even beneficial to slightly move them in order to get the wands to the right spot.
I still liked the way of adjusting air/media mixture on the media tank instead of using the valve at the wand. With all valves fully open it seemed like I didn't have enough air throughput to achieve good cleaning.
The blue tarp is probably an overkill. I was afraid that I would blast through a thin plastic if I should ever slip out of the vacuum adapters. While that didn't happen, I still have some walnut media all over the engine. So be sure to tape off the ports you aren't working on.
|