[Ch3ss]

My09 335i have been throwing these codes lately. The can runs fine even during WOT but the SES just keeps comming back even after clearing it with BT cable. The car is stock. I've tried searching but there is no definite answer on how to get rid of these codes so if someone can chime in and point me in the right direction it would be greatly appreciated.

here are the codes that keep popping up.

Current Fault Codes

29E1
29E1 Fuel mixture control 2
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Timeout

Freeze Frame Information
Event 1Odometer 105224kms 65383miles
speed 640.00 rpm
suction pipe pressure 42.00 kPa
relative load 0.00 %
matching throttle valve model (factor) 0.97 -

Event 2Odometer 105232kms 65388miles
speed 640.00 rpm
suction pipe pressure 37.00 kPa
relative load 0.00 %
matching throttle valve model (factor) 0.99 -


2A2C
2A2C Fuel mixture control 2
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption

Freeze Frame Information
Event 1Odometer 105224kms 65383miles
speed 704.00 rpm
suction pipe pressure 42.00 kPa
relative load 0.00 %
matching throttle valve model (factor) 0.98 -

Event 2Odometer 105232kms 65388miles
speed 832.00 rpm
suction pipe pressure 34.00 kPa
relative load 0.00 %
matching throttle valve model (factor) 0.97 -



2C28
2C28 Lambda probe in front of catalytic converter 2, system check
Error will cause a warning light
Error is not currently present
Test conditions have been completed
Short circuit or signal interruption

Freeze Frame Information
Event 1Odometer 105240kms 65393miles
ceramic temperature Lambda probe in front of catalytic converter bank 2 0.00 °C
voltage Lambda probe behind catalytic converter bank 2 0.96 V
Lambda-nominal value group 2 0.99 -
voltage Lambda probe in front of catalytic converter bank 2 2.66 V