Quote:
Originally Posted by CobraMarty
The modified support will not have any influence on the eccentric shaft angle.
Whatever your maximum ECC angle is before the modified supports are added will be the same after the modified supports are installed.
Version 1 has one area modified for increase lift.
Version 3- now at the machinists has version 1 mod + version 2 mods which is 2 more areas modified for even more lift.
|
right, I just mean the assumption currently is that the current maximum eccentric shaft position is actually 175 degrees, not 180 degrees (as it is in software). So basically, commanded 180 degrees = 175 at the sensor, which is the same as ~10.6mm of lift. I was saying, if this is indeed true - then my earlier comments are moot.
Although, I'd like to see what it does with version 3.. if only my engine actually leaked oil, I'd have an excuse to get these popped in there already.
