View Single Post
      02-01-2016, 09:12 PM   #18

Drives: Car
Join Date: Aug 2014
Location: Location

iTrader: (0)

Originally Posted by jpregione View Post
I understand.. no real burning questions... except maybe does it help any to take wheel well out when doing the job?
No. You don't need to take off wheels. Just raise the car. Since i don't have the lift, i used jack stands and the drive on ramps to lift the car by a foot of the ground.

I back up the rear wheels on the ramps and then lifted the front end. car was supported by jack stands. I think they were on 4th notch.

Everything is accessible from above and below. While removing the headers, you will mostly work from the above. During the installation, you will have to tighten some bolts from the below.

Btw. After you put on about 500-1000 miles, you will need to retighten all nuts again - double check them for just in case they got lose.