Quote:
Originally Posted by iaknown
Quote:
Originally Posted by Mik325tds
Much more important is to stay away with the drill/reamer from the flap that closes the waste gate, which unfortunately I also did not manage to achieve .
After finishing the drilling I used a counter sink and then a small file to clean the edge of the hole to make sure the flap closes well.
|
It is impossible not to stay away from the flapper without relieving behind it to get it to open up further. But you had already done this before I could give you that tip
Good thing you didn't go bigger because that nick would be much worse.....
|
Relieving? Could you explain for us who have not done this yet?