Finally got around to replacing the sensor today, was very tight under the car! Couldn't get the hight jacking from diff to get higher up on stands. Getting the reinforcement plate off was a nightmare, 2 of the screws were properly seized but got there in the end just about, was worried might round off the head when hammering the wrench!
Once the plate was off wasn't so bad, apart from the space..what a place to put the control module ffs! 2 inch from prop shaft, nice one! Was very happy once I had threaded that farside nut, bit concerned should of tightened some more now.. oh well!
Thankfully DIS setup from disc seemed to have worked out of the box so to speak so was happy with that! Did the replacement stuff and have reset adaptations as also replaced injector other week, so was holding off to get it all done.
Quick check in inpa showed lambda was going up to 3 so deffo running stratified
will see what mpg is like once it settled..smooth running for now
