Quote:
Originally Posted by neilvan
I just installed some MMP inlets (as well with new turbos and outlets)
I had to trim the front inlet to fit with my Dinan intake (stock airbox the same) as it was too long
I also ran 90* adapter and hoses for the BPV's as the angle coming out is wrong.
Some heat sleeves I felt were a good idea around the front and back because of how tight it was and rubbing.
Absolutely cut down a T30 torx bit and vicegrips for the rear inlet torx. Both bother screwing around with anything else.
Its doable just take your time. Lots of swearing from me. These cars are much tighter than I'm used to for engine bays.
|
Where did you get the 90 degree adapter ?
I would have loved to have a 45 degree adapter for the front turbo when I did the 2" MMP Silicone Outlets.