Quote:
Originally Posted by VP Electricity
Categorically disagree. CS will properly calibrate so long as you do not expect full-range out of it. Measure the output. You won't get a green LED, but if you measure the output, you aren't trying to draw a conclusion from a multicolor LED.
Edited to add "out of the rears" - you will of course get full-range signal from the front outputs.
|
When you measured it, what was the actual output if the inputs are not summed? I quit using the CS long time ago because of the sum requirement by a separate module.
JL Audio talks about noisy output as well as the obvious failure to calibrate if non-full range signals are input.
