Quote:
Originally Posted by Sensible_
Quote:
Originally Posted by Ronin2
It is the module for sure. We tested the pump and it works good. The module number is 3452 6778237-01. I am getting a used one.
|
Ok. In which case install the DSC then change VIN + default code to your VO.
Once done, you'll probably have fault codes. You should perform the Steering Angle and DSC Adjustment procedures by ISTA D |
How would one go about doing that?
I'm new to all of this. I'm getting the trifecta. I bought a Foxwell scanner and it's consistently giving me 5DF0/5DF1 which from all the reading I've done it looks like the pump is the culprit. I've tried knocking the pump motor cover and that worked for a bit, but now the code is back.
I don't really have the luxury of a 2wk down time, so I was thinking of buying a used one, sending it to Module Masters for the rebuild and then installing just the rebuilt pump on my existing DSC. If after the bleed that does not work, I'd pull out my DSC and put in the rebuilt one from MM, at which point I'd need to recode it to my vin/VO as you state above.
How does one do that? In some of the other threads it sounds as though it's not possible and you must take it to the dealer.
Any help would be greatly appreciated.