Today I tried the headlights, only one angel eye since the outer ones cable broke off but still, just wanted to check functionality and see that I get no fault codes. Success!
No fault codes, angel eye is working properly since I tapped into the wires correctly.
When I have done the other light and mounted both of them should I will use bavgruppe's guide regarding changing the voltage and coding some changes? When I have the light switch att off/0 it lights up well, when I set it to right so what I think is only angel eyes, it's bright, when I go to low beam or auto it will lower the output of the LED. Is it fine?
Last edited by Swedish Salmon; 01-05-2021 at 09:26 PM..
|